PDA

View Full Version : Rol-plow



TonyM
18-03-2011, 07:18 PM
Does anybody know who manufactures the rol-plow? I've had mine repaired because the head popped of due to the wearing away of the alloy plate that holds it on, but now the head isn't as manoeuvrable. I need to know if I can just buy the plate as I don't want to fork out 200 for a new one.

Goodmanatee
21-03-2011, 08:19 PM
Sorry tony don't know the answer to that.
But how do you use your Rol plow? I know you don't use a taper.
If putting tapes up with taper, could you miss rolling the tapes and go straight for the Rol plow to finish them?

TonyM
21-03-2011, 08:55 PM
Sorry tony don't the answer to that.
But how do you use your Rol plow? I no you don't use a taper.
If putting tapes up with taper, could you miss rolling the tapes and go straight for the Rol plow to finish them?

Yes mate.
1. Pud in corner
2. Add tape
3. Rol-plow beds tape with its wheel and flushes with blade.

If sufficient mud is put into the corner, the rol-plow gathers this and pre coats the tape.
The only downside is that it doesn't get right in the corner at the ceiling.