PDA

View Full Version : Help



Oops
06-11-2014, 05:08 PM
Hi guys and any gals I'm seeking some advice.....

Got to deal with a tapered to square edge join without ripping down the board what would be the best way to go about it? It was unavoidable as the tapered edge had to be used around a window with corner beading so it's two boards vertical either side of the window with a horizontal board underneath which leaves two tapered to square joins to address.

TonyM
06-11-2014, 06:18 PM
If you have the time, fillthe taper out first then treat it like a butt joint. If you don't have the time, just tape it and feather the bump out a bit wider

Oops
06-11-2014, 06:31 PM
If you have the time, fillthe taper out first then treat it like a butt joint. If you don't have the time, just tape it and feather the bump out a bit wider

Seems reasonable and have plenty of time so I will give it a go... Thanks for the advice