PDA

View Full Version : Concorde Box handle Schematic



taperseth
28-08-2009, 03:54 AM
hey there,

if anyone has a schematic for it, it would help a ton thanks. also not sure where to get parts. if i still can.
Thanks in advance for any help.

Seth

taperseth
28-08-2009, 04:06 AM
so clearly i did that wrong. sorry. any help would be nice in both cases

belmoreboy
28-08-2009, 04:26 PM
Hi Taperseth,

Well could be a small issue concorder tools no longer in production, the were bought out by Tapetech about 8 years ago.

For concorde Taper parts see Tapetech drawing as it's as near as you will get /(check prices through our site) if part mega bucks then give rob in our workshop a call first to make sure part will fit and stocked.

For box handle, it maybe one or two variations either tapetech standard or Northsatr extendable. Best bet is if possible take a quick snap on your mobile phone camera and text to me on 07798860155 lots of tapers do this and it makes identifying the part you need easier.

I will upload tapetech standard handle and northstar ext handle schematics tonight - take a look and see if it looks familiar to these.

Either reply here or call at office on 01603 787464 or my mobile anytime

Cheers

Marcus

taperseth
31-08-2009, 01:12 AM
Hey there Marcus,

thanks for your help it helped alot. i figured out one of the parts i need to replace is called the quadrant. (the brake disc to me) it looks exactly right. right down to the screw hole placement. however i still have a problem. i'm not sure what the triangular piece that is pushed into the grooves on the quadrant is called. its attached to the pivot arm, when the handle brake is pushed it is pressed against the quadrant. what that little piece is called. all the schematics i found didn't make it clear. any help would be absolutely wonderful.
i appreciate your help already and hope that was clear(ish).

P.S. if i can e-mail a pic to you, if that would help i will.

Seth

belmoreboy
01-09-2009, 04:34 PM
Hi Seth

Apologies for delay (supposed to on a small holiday - but just noticed your post and hate to see a taper stuck !)

I think the part you may be referring to is part no 9 on the drawing pivot plate or pivot arm they call it (attached picture) if not im a little lost - and best bet would be to call our workshop manager Rob - theres not a lot he doesn't know about taping tools - he will see you right ! (01603 787464)

Hope you can it sorted - if not pm me or post back!

Cheers

Marcus

drywall finisher
10-09-2009, 09:37 PM
Do you know of anybody having a schematic drawing on the first battery operated bazooka from AMES ? or the bazzoka itself ?