PDA

View Full Version : Tapetech Roller Bolt/Bushes



sejlane
23-03-2010, 08:45 PM
I'm looking to replace one of the bolts with the attached bush that hold the nylon roller wheel to the Roller body as it is bent and doesn't run true , any idea on where i can get the replacement part ? is it a standard size bolt that i could get from say screwfix or something ?

turrican_007
24-03-2010, 09:23 AM
Try one of these.

http://www.walls-and-ceilings.co.uk/default.asp

http://www.belmoretools.co.uk/

belmoreboy
24-03-2010, 03:33 PM
Think you mean one of these mate, not standard size bolt as it's usa made

Roller Axle, 1/4-20x1-1/4 He

2.93 + vat and delivery (24/03/10)

215

Give me ashout if you need one, got a few in stock.

sejlane
24-03-2010, 05:20 PM
Think you mean one of these mate, not standard size bolt as it's usa made

Roller Axle, 1/4-20x1-1/4 He

2.93 + vat and delivery (24/03/10)

215

Give me ashout if you need one, got a few in stock.


Looks similar but has a bush built on that the nylon wheel sits on , the one in the pic has no bush so i think it would be too much movement for the roller . I;ll get a pic up later of the bolt i've bent .

belmoreboy
25-03-2010, 09:00 AM
The bushing i think you mean is a separate part slides over the bolt picture below:
2164.84 + vat (25/03/10)

Prrobably worth changiong the brass washer unless it can clean up ok
2171.30 + vat (25/03/10)

sejlane
25-03-2010, 06:17 PM
The bushing i think you mean is a separate part slides over the bolt picture below:
2164.84 + vat (25/03/10)

Prrobably worth changiong the brass washer unless it can clean up ok
2171.30 + vat (25/03/10)
Thaks i'll give you a call , i'll check you site now may need a few other bits and peices .