Results 1 to 5 of 5
Thread: Coving coombed ceilings
Taping, boxing, nailspotting, internal & external corners, sanding etc.
-
04-08-2011, 06:32 PM #1
- Join Date
- Mar 2009
- Posts
- 150
- Thanks
- 7
- Thanks
- 11
- Thanked in
- 11 Posts
Coving coombed ceilings
I've seen it done but never tried it myself and wondered if any of you guys have.
Do you put the cove on the coombed edge first then work round the flat and scribe to match up?
-
04-08-2011, 09:40 PM #2
- Join Date
- May 2010
- Location
- East Kilbride, Glasgow
- Posts
- 1,390
- Thanks
- 387
- Thanks
- 200
- Thanked in
- 178 Posts
Never tried it Matt nor have I seen it done. Personally I think it would look hideous, did it look ok when you seen it ? Is it a customer's preference, or are the coombs all to pot?
-
05-08-2011, 01:41 PM #3
- Join Date
- May 2010
- Location
- SCOTLAND
- Posts
- 528
- Thanks
- 22
- Thanks
- 75
- Thanked in
- 69 Posts
Like EK i hav never seen it done either, think it would look pretty s**t TBH
-
05-08-2011, 03:41 PM #4
I've done it but it looks pants. Mitre the joints from slope to flat.
-
05-08-2011, 03:49 PM #5
- Join Date
- Mar 2009
- Posts
- 150
- Thanks
- 7
- Thanks
- 11
- Thanked in
- 11 Posts
It was s shaped gyproc 135 cove and it matched up and I think it looked alright, but probably too much hassle.
I might do as tony says and mitre it into the slope, if i can get the angle!!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mf ceilings
By Tex taper in forum Board hanging and dryliningReplies: 5Last Post: 27-08-2013, 08:24 AM -
Arrow (walls n ceilings) gyproc or knauf
By chabev10 in forum Taping tools and materialsReplies: 22Last Post: 24-02-2012, 04:52 PM -
Walls and ceilings arrowlite
By ducatster in forum Taping tools and materialsReplies: 3Last Post: 10-04-2011, 05:48 AM -
Taping coombed ceilings
By kev in forum Taping, jointing and drywall finishingReplies: 4Last Post: 25-02-2011, 11:25 PM
Bookmarks