bristol taper new to site

[nickytaper]

hey, am a taper in bristol been tapin for over 10 years, not much on houses any more, but am always busy n recently left a firm to become selfemployed again. i use bte tube n angle heads for my internal corners n hawk n trowel on streights n flexes, 3 coats on streights n 2 on corners, n sand wiv flex sander n vac, saves on mess n sucks the dust of the wall for mint finish, i can honestly say i think it would take an exceptional plasterer to get a better finish than i can!! just found this site after tryin to find out what other tapers r charging n getting! i thought the going rate was around 2£ m2 labour only but herd roumors people r gettin double that, n do people charge xtra linear metre for external angles? oh well look forward to reading yer posts!! nick.

[TonyM]

Welcome to the forum Nick.

[amestaper]

Hello Nick. Nice to see you.

[nickytaper]

thanks!

[E.K Taper]

Hi Nicky, good to have ya on board.
£4 per metre labour only? I'm on my way down!

[nickytaper]

cool, was startin to think id been workin for the wrong people all this time!! good to c this forum is so active.

[ColumbiaTechSupport]

Welcome Nick